Free 3d tutorials: from 3d tips & tricks to advanced 3D software tutorials in 4 seconds.


“Dino” by Glen Southern

Extrude and scale down as shown

And again to get the tail shape as shown

Select two faces at the hip section.
Extrude outwards

Select the underside of that last extrusion.
Extrude down to form the thigh

And again to form the ankle
Keep rotating the faces as needed to match the model below

Extrude the lower leg/foot

and two more to create the toes

We need to start adding more geometry to refine the basic shape next.

Select two faces that go around the neck.
Use Select Loop and then Split loop

Do the same around the chest area

Pages: 1 2 3 4 5 6 7 8 9

Leave a Reply