“Tire modeling in Maya” by Aziz Khan
38-now extrude 3 times and change the width scale as below.
39-now it should look something like image below.
40-its time to start working on tire, once again create a pipe then apply the settings as the image showing below.
41-now go to edge mode and select the 2 indicated edges in the image below then with CTRL right mouse button choose (Edge Loop Utilities) like the one below.
42-then choose as below.
Tire modeling tutorial
3 comments
Leave a Reply
You must be logged in to post a comment.
step 9 and 10 dont make any sense, you dont have an edge, and then you do, what is the deal with that?
THANX, I WAS LITTLE CONFUSED IN HOW TO CREATE GRIP FOR TYRE… NW ITS GO…
very beautifull and i was searching for it…..wait is over