Free 3d tutorials: from 3d tips & tricks to advanced 3D software tutorials in 4 seconds.

Cartoon fish tutorial

Posted by in Beginners, Modeling | 7 comments

"Cartoon fish" by Aziz Khan
26-now go to top view and then (Edit Mesh>>Split Polygon Toll),

27-still in the top view create the edges for the back fan, like on the image
showing below,

28-go to face mode and then select the faces showing below and extrude them
out, also don’t forget to scale it a bit in X axis to make it thinner,

29-extrude one more time with the same procedure you did above,

30- extrude for the last time with same procedure,

 

     

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

7 comments

  1. best blender / November 21, 2011

    I am now not positive the place you are getting your information, but good topic. I must spend some time learning more or understanding more. Thank you for wonderful information I was in search of this information for my mission.

  2. gomathi / November 10, 2011

    nice……..

  3. chillman / June 19, 2011

    could you please update the tutorial!!!! this is cinema 4d r6 or something i’m using r12 kinda hard to do when nothing of these things exists or are called other things……

  4. Clarisse / September 10, 2010

    Very helpful tutorial! Thank you so much. 🙂

  5. SookYee / September 8, 2010

    The link to the reference image is kinda faulty, I arrive at a page that have gibberish words…what’s going on?

  6. bhupender / September 6, 2010

    thanks for this tutorial

  7. pavan / July 21, 2010

    thank u for yr service

Leave a Reply